Method for using water purification agent in frame pool and inflatable pool

The hot summer is the peak season for projects such as frame pool and inflatable pool, but it is also a good time for mosquito bacteria to breed. Therefore, the quality of water in swimming pools is also one of the issues that investors are most concerned about.

First fill the swimming pool with water, and then add the pool algicide to the pool. (Algae has two types: algae special for swimming pool and copper sulfate used in industry. For specific instructions, please refer to the package.) Wait 12 hours before proceeding to the next step.

Then add disinfectant, 3-5KG per thousand cubic meters of water (new water should be doubled). Dispense evenly and start the circulation pump when applying the medicine. After two hours, check the residual chlorine. If the residual chlorine is less than 0.5ppm, refill it. Add 1KG (per thousand cubic meters of water) disinfectant.

When the pool water is turbid or colored, and the turbidity of the water does not reach the standard, it can be solved by adding a clarifying agent. After the clarifying agent is added, the circulation equipment is turned on, and most of the impurities will be filtered out by the filtering equipment, and a small part of the sediment will be absorbed by the dirt suction machine. In addition, after the swabs deposited on the bottom of the pool are cleaned up, it is best to add water quality stabilizers to keep the pool water stable and difficult to change. However, it should be noted that disinfectants cannot be administered at the same time as alkali, otherwise the disinfection effect will be reduced.

Use PH lowering and raising agents to adjust the PH of the pool water.
The national range of PH value for swimming pool water is 6.8-8.2, and the best range is 7.4-7.6. First of all, this PH value will not cause irritation to human skin and eyes, and it is more comfortable, the most important thing is that in this PH value range, both the disinfection effect of the disinfectant and the remaining chlorine can be maintained for a longer time. Therefore, the pH value of our swimming pool water should be kept as low as 7.5, so as to ensure the effect of disinfection and maximize cost savings.